Brake and Clutch levers are not all alike and any time you're installing an aftermarket cable pull brake or clutch perch you'll almost certainly have to build a new cable to go with it.
Our Signature Universal Brake or Clutch Cable Kit contains all the necessary components to help you build your own high quality cable.
We've collaborated with the experts at Venhill Engineering to develop a kit to service all of the levers available here on our site as well as nearly any other lever you might come across.
Each kit provides enough material to build a single cable along with a selection of ferrules, elbows, adjusters a variety of the most common nipples with a spare of each in case you need a do over.
Check out our Honey Pot Cable Soldering Kit here
Highlights:
-
Black or Clear Braided cable housing to match our Hydraulic Brake Lines and Fittings.
-
Spiral wound steel conduit covered in tough PVC.
-
Smooth action Teflon liner.
-
Galvanized steel cable for easy soldering and durability.
-
A torch and basic soldering tools required for assembly. Don't forget to check out our Control Cable Bird Cage Tool!
-
1.35 meters (4.4 feet/4 feet 4.8 inches/54.8 inches) of 8mm OD braided PVC coated, spiral wound, Nylon lined outer conduit
-
1.6 meters (5.25 feet/5 feet 3 inches/63 inches) of 2mm OD galvanized steel wire (1 x 19 strand)
-
2 x ferrule, 7mm OD nose
-
2 x ferrule, 7mm OD nose
-
1 x neoprene adjuster boot
-
2 x brass barrel nipple, 8mm DIA x 9mm
-
2 x brass barrel nipple, 6mm DIA x 10mm (2.1mm bore)
-
2 x brass trumpet nipple, 6mm -> 3.5mm OD, 2.5 ID, 9.5mm length
-
2 x brass bar nipple 10mm DIA x 10mm, slotted
-
1 x N8 nylon nipple sleeve, 8mm OD
-
1 x N10 nylon nipple sleeve, 3/8" OD
-
1 x Accordion Adjuster Boot
-
1 x BMW clutch cable fitting
-
1 x Lock nut M8 x 1.25mm
-
1 x Steel adjuster screw M8 x 1.25 x 42mm